Techgrip RTT1 is a BBA/HAPAS certified superior quality thermoplastic resin based high friction surfacing system. It is a type 1 HAPAS/BBA approved system incorporating graded calcined bauxite aggregate. Available in various colours including buff, grey, red, and green.

BENEFITS
– Excellent coverage.
– Application not seasonally affected.
– Minimal curing time.
– Can be trafficked within 30 minutes.
– Coloured to suit requirements.
– Will regulate minor surface irregularities.
– Excellent wearing qualities.
– Superior ride quality.
– Easy to apply.

Duragrip is a 2-component epoxy resin based high friction surfacing system. This system has been developed for application to road surfaces in combination with calcined bauxite to form a hard-wearing high-performance anti-skid road dressing. Also available in a Low Odour form.

BENEFITS
– Convenient mix ratio 1:1 by weight
– Excellent physical properties
– Resistant to oils and solvent spillages

APPLICATIONS
– Junctions & Pedestrian Crossings
– Roundabouts
– Sharp Bends
– Feeder and exit lanes
– Accident ‘black spots’

Note: New asphalt should be left for a minimum of four weeks, depending upon vehicle traffic. This is necessary to allow any volatile oils in the asphalt to oxidise. Duragrip may be applied to concrete surfaces with a suitable primer.

Duragrip PU is a 2-component polyurethane resin based high friction surfacing system. The system has been formulated to produce a coating for bonding aggregate to steel, asphalt and concrete for anti-skid, decorative and surface protection purposes. Duragrip PU is especially suitable for the coating of ship decks and bridges due to its flexibility and excellent adhesion to steel.

BENEFITS
– Convenient mix ratio (3:1).
– Excellent physical properties
– Resistant to oils and solvent spillages

APPLICATIONS
– Bridge decks
– Ship decks
– Junctions & Pedestrian Crossings
– Roundabouts
– Sharp Bends
– Feeder and exit lanes
– Accident ‘black spots’

Note:
New asphalt should be left for a minimum of four weeks, depending upon vehicle traffic. This is necessary to allow any volatile oils in the asphalt to oxidise. Duragrip PU may be applied to porous surfaces with a suitable primer.

Techgrip CL is a coloured thermoplastic surface treatment specially formulated to give excellent ride quality on all cycle routes, bus lanes, gateways, stop boxes and lay-bys. Fast cooling to reduce traffic disruption. Available in various colours including red and green.

BENEFITS
– Economical.
– Application not seasonally affected.
– Minimal curing time.
– Can be trafficked within 30 minutes.
– Coloured to suit requirements.
– Will regulate minor surface irregularities.
– Excellent wearing qualities.
– Superior ride quality.